Floor Scraper

The only scrapers I could find were hand scrapers, then a long handled ice spud that was 5" wide. The one seen in the droppings collector page. Finally it was decided to make a floor scraper that would make the job easier. With a piece of flat steel bar I had and a garden tool handle this was made. The handle had a thread on the end that was cut off, a hole drilled and tapped for the 1/2-20 bolt.
I does the job with less bending over. The droppings are easily moved to the collectors. The cost was about 2 hours of time and $7.50 in material.